Commissioning
3.3.1
Installation of the Object Manager for STEP 7
Prerequisites
Installing the
object manager
Configuring the
hardware
Indicating
integrated help
3-14
To install the object manager (OM), STEP 7 (starting with V3.2) must be
installed correctly on your PG/PC.
To install the object manager, proceed as shown below.
1. Make sure that no applications are open in Windows.
2. Insert the data medium.
3. Call the SETUP.EXE program.
The CM35 counter module is located in the path shown below under STEP 7
! HW Config ! Catalog.
Figure 3-3
Counter module CM35 in the hardware catalog
In addition to the dialogs of the object manager, help information is available
which you can call during every phase of parameterization either with the F1
key or with the Help button.
CM35 Counter Module
(4) J31069-D0416-U001-A5-7618