Table of Contents
Advertisement
7.2
Parameterization
CM35 Counter Module
(4) J31069-D0416-U001-A5-7618
This chapter describes possible parameterization in timer mode which you
can use to adapt timer reactions to your task.
The parameter data are divided into three parameter blocks. For the structure
of the parameter blocks, see chapter 7.2.2. The descriptions of the individual
parameter data include the number of the parameter block and the offset in
the related structure.
To be able to utilize ²timer² operating mode, you must transfer parameter
blocks 1, 2 and 3 to the CM35.
Note
The timer must be stopped before it can be reparameterized.
- - When you want to change timer- - specific parameters, you must stop
the applicable timer.
- - When you want to change timer- - overlapping parameters, you must
stop all timers.
The new parameter data take effect when the timer is started again.
For a description of the general layout and transfer of the parameter blocks,
see chapter 4.2.
Timer Operating Mode
7-3
Advertisement
Table of Contents
