Table of Contents
Advertisement
Period Duration Measurement Operating Mode
6.2
Parameterization
6-4
This chapter shows you available parameterizations in ²period duration mea-
surement² mode which you can use to adjust the reaction of the measuring
channels to your task.
The parameter data are located in a parameter block. For the structure of the
parameter block, see chapter 6.2.2. The description of the individual parame-
ter data includes the number of the parameter block and the offset in the
structure.
You must transfer parameter block 1 to the CM35 before you can use ²period
duration measurement² mode.
Note
The channel must be stopped before it can be reparameterized.
You must stop the channel before you can change the channel- - specific pa-
rameters.
The new parameters take effect the next time the channel is started.
For a description of the general layout and the transmission of the parameter
block, see chapter 4.2.
CM35 Counter Module
(4) J31069-D0416-U001-A5-7618
Advertisement
Table of Contents
