Operational Safety And Special Dangers - Fasel Elektronik FCU2000 Series Installation Instructions Manual

Safety
1.6

Operational safety and special dangers

Pay attention to the safety and warning notes in the following chapters of this manual to
minimize health hazards and to avoid dangerous situations.
The following instructions are to be adhered to for your own safety and the safety
of the unit:
Electric
potential
8 Installation instructions Steam bath control Series FCU2000/FCU3000/FCU4000/FCU5000 M_FCUxxxx-Steam_EN / Version V2.04
DANGER!
Danger to life due to electric potential!
Contact with live components can be fatal.
Damage of the insulation of the individual components can be
dangerous to life.
Therefore:
– For switching off the mains, the power supply cable must be
equipped with a fuse with a contact opening width corresponding to
the requirements of the excess voltage category III for total
disconnection.
– Disconnect the unit from the mains before carrying out any work on
it (switch off the fuse in the distribution box) and secure against
restarting. Check for zero potential. The control device should be
disconnected from the mains before opening the casing.
– In case of damage to the insulation, switch off the power supply
immediately and carry out the repair.
– Work on electrical unit should be carried out by certified electricians
only.
– Never bypass fuses or put them out of operation.
– While replacing fuses, pay attention to correct current specifications.
– Keep moisture away from live components, since it can lead to
short circuit.
WARNING!
If a short circuit occurs in a 230V/400V load, the relay contact can
be welded by the high short-circuit current. Is turned on before
removing the short circuit, the safety relay can be also welded.
This can lead to the continuous operation of the load. Turn off the
circuit breaker in the junction box. Send the unit back to the
factory for check/repair.