Technical Safety Notes For Assembly And Installation; Intended Use; Modifications And Alterations - Fasel Elektronik FCU2000 Series Installation Instructions Manual

Safety
1.2

Technical safety notes for assembly and installation

1.3

Intended use

Depending on the version, the FASEL steam bath controls of the series FCU2000,
FCU3000 and FCU4000 are exclusively meant for operation and control of steam bath
cabins. The control devices are permitted for domestic and commercial application.
Intended use
Claims of any type due to damages caused by improper use will not be accepted. Only
the user is responsible for damages caused by improper use.
1.4

Modifications and alterations

Modifications and alterations of the steam bath control or installation can lead to
unforeseen dangers.
All technical modifications and add-ons to the steam bath control require the written
permission of the manufacturer.
6 Installation instructions Steam bath control Series FCU2000/FCU3000/FCU4000/FCU5000 M_FCUxxxx-Steam_EN / Version V2.04
DANGER!
The control device can be installed directly on the outer side of the
cabin or at another location, however not within the cabin
Note!
Appropriate VDE applies to public steam baths, that a control
lamp, showing, that the evaporator is switched on, is to install in
the room of the supervisor.
This lamp can be connected to the clamp
For switching off the mains, the power supply cable must be
equipped with a fuse with a contact opening width corresponding
to the requirements of the excess voltage category III for total
disconnection.
At FCUxxxx-Steam-Design-Glas the main switch of the control unit
must be accessible.
The sensor of the thermostat must be installed in such a way that
it is not affected by the incoming cool air.
WARNING!
Danger if not used correctly
Any improper use of the steam bath control can lead to dangerous
situations.
Therefore:
– Use the steam bath control as instructed.
– Operate the steam bath control only within the permissible room
temperature and moisture range. → See page 9.
– All the specifications in the operating manual and the installation
manual must be strictly adhered to.
(FLE-STB).