Checks Before The Initial Commissioning; Switching On And Off The Steam Bath Control - Fasel Elektronik FCU2000 Series Installation Instructions Manual

Commissioning
Improper
operation
Danger of
scalding
Health hazards

10.2 Checks before the initial commissioning

The following points should be checked before the initial commissioning:

10.3 Switching on and off the steam bath control

Read the operating manual and the safety instructions thoroughly and follow them
before switching on.
→ See operating manual "Series FCU2000/FCU3000/4000".
28 Installation instructions Steam bath control Series FCU2000/FCU3000/FCU4000/FCU5000 M_FCUxxxx-Steam_EN / Version V2.04
WARNING!
Improper operation can lead to serious injuries.
Therefore:
– Read and follow the operating manual.
WARNING!
Danger of injury due to scalding!
Objects on the steam inlet or in the surrounding area of the vaporiser
can cause scalding and thus lead to injuries.
Therefore:
– Always keep the steam inlet and the surrounding area of the
vaporiser free of objects.
WARNING!
Danger of injury due to covering of the temperature sensor!
Covering the cabin sensor can lead to increased temperature. The
increased heat can lead to health hazards or to serious injuries.
Therefore:
– Do not cover the cabin sensor.
– Ensure unrestricted air circulation.
Does the voltage supply match the specifications on the nameplate?
Have the cable specifications as per Table 4, page 11 and the electrical circuit
diagram Figure 11, page 26 been adhered to?
Is the control device connected as per the electrical circuit diagram?
Are the sensors (temperature) connected as per circuit diagram Figure 11?
Have all the neutral conductors been laid on the N- bus bar in the steam bath control
device?
Have all the earthing conductors been laid on the PE-bus bar in the steam bath
control device?
Have all the screws been tightened correctly?