Troubleshoot - FlowLine EchoPod UG06 Series Quick Start Manual

#3 - S SETTING TH HE HEIGHT (S
This setting cust tomizes the
Follo ow these ins structions to
1) I n TOP-LEVE EL MENU m
2) S Select HEIG HT.
3) U Use the UP a and DOWN
H HEIGHT of y your tank.
4) T To enter the v value, press a
s seconds and release. SA
H HEIGHT is no ow set.
5) S Select FILL- -H.
6) U Use the UP a and DOWN
HEIGHT of y H your tank.
7) T To enter the value, press
seconds and s d release. S
FILL-H is now F w set.
8) T To enter the value, press
FILL-H is now F w set.
9) S Select EXIT to return to
10) S Select RUN to return to O
Note e: The Heig ht and Fill H
The Height settin ng determin
#5 - H HOW TO SEL LECT FAIL-S
In th e event the sensor does
the F Fail-Safe Cu urrent Output
be s et to output a current of
22m mA or HOLD (last known
safe , the display y will read LO
1) In TOP-L 1 LEVEL MEN
2) Select 4m 2 mA, 20mA,
HOLD. S SAVED will
3) Select EX 3 XIT to return
MENU.
TRO UBLESHOOT TING
If yo u face any is ssues not ad
Flow wline's websi ite at www.fl
| 8
SENSOR HEI IGHT) & #4 -
reading for y your installa
set the heig ht and fill he
mode, select TANK.
buttons, set t the
and hold OK K for 3
AVED will disp play.
buttons, set t the
s and hold O OK for 3
AVED will d display.
s and hold S SELECT for
the TOP-LE EVEL MENU
Operational Mode.
Height setting gs also dete
es the 4mA position and
SAFE CURRE ENT OUTPUT
s not receive e an echo,
t or LOST se etting can
4mA, 20mA A, 21mA,
value). Dur ring fail-
OST.
U mode, se lect SAFE.
21mA, 22m mA or
display.
n to the TOP P-LEVEL
ddressed in this Quick S
owline.com. .
SETTING TH HE FILL-H (F
tion.
eight for your r tank:
2 seconds a and release.
.
rmine the 4 to 20 mA cu
d the Fill-H s setting deter
T (LOST)
Start, please refer to the
ILL-HEIGHT) )
SAVED wi ll display.
urrent span.
mines the 20 0 mA positio
®
EchoPod Manual locat M
on.
ted on
QS310140 Rev A A1