Powering Off The Workstation - Sun Microsystems Sun Blade 2500 Getting Started Manual

1. Turn on power to the monitor and to all external devices.
2. Press and release the workstation Power button on the front panel (
3. After several seconds, verify that the power-indicator LED on the Power button
lights.
The power-indicator LED on the Power button lights after the workstation begins
the internal booting process (
If you experience problems during power on, see
2500 Workstation" on page
Tip – After you power on the workstation for the first time, you are ready to set up
the preinstalled Solaris 8 2/04 and Solaris 9 9/04 Operating System software. Go to
"Planning the Installation Process for Solaris" on page

Powering Off the Workstation

describes two methods for powering off the workstation.
TABLE 1-1
Powering Off the Workstation
TABLE 1-1
Method
Method 1
Method 2
Note – After powering off the workstation, always wait at least four seconds before
powering on the workstation again.
).
FIGURE 1-3
35.
Instructions
1. Close and save any open applications.
2. Press the Sleep key (or press and release the Power button).
3. Select Shutdown.
1. Close and save any open applications.
2. As superuser, type:
shutdown
Chapter 1 Setting Up the Sun Blade 2500 Workstation
FIGURE 1-3
"Troubleshooting the Sun Blade
11.
).
9