Table of Contents
Advertisement
HART Multiplexer System KFD*-HM*-16
Safety instructions
2
Safety instructions
2.1
General safety instructions
2.2
Used symbols
Warning
Attention
Note
2.3
Declaration of Conformity
Note
6
The operator of the system is responsible in terms of planning, mounting,
commissioning, operating and maintenance.
Installation and commissioning of all devices must be performed by a trained
professional only.
Protection of operating personnel and the system is not ensured if the product is not
used in accordance with its intended purpose.
Laws and regulations applicable to the usage or planned purpose of usage must be
observed. Devices are only approved for proper usage in accordance with intended
purpose. Improper handling will result in voiding of any warrantee or manufacturer's
responsibility.
The Declaration of Conformity, Certificate of Compliance and data sheets are an
integral part of this document. The data sheet contains the electrical data of the
Declaration of Conformity and the Certificate of Compliance.
The documents mentioned are available from http://www.pepperl-fuchs.com or
contact your local Pepperl+Fuchs representative.
This symbol indicates a warning about a possible danger. Failure to observe this
warning may result in personal injury or death, or property damage or destruction.
This symbol warns of a possible fault. If the instruction given in this warning is not
heeded, the device and any plants or systems connected to it could develop a fault
or even fail completely.
This symbol brings important information to your attention.
All products have been developed and manufactured taking into consideration
applicable European standards and regulations
A Declaration of Conformity can be requested from the manufacturer.
The manufacturer of this product, Pepperl+Fuchs GmbH in Mannheim, Germany,
has a certified quality assurance system in conformity with ISO 9001.
ISO9001
Advertisement
Table of Contents
