Connection With The Device - Pepperl+Fuchs KFD HM 16 Series Manual

HART Multiplexer System KFD*-HM*-16
Configuration
6.3

Connection with the device

Installing the software components
The installation of the software components is described in the "PACTware
Installation Instructions" manual. Please observe the sequence of the installation
steps and the instructions in the installation instructions.
 Install Microsoft .NET Framework.
®
TM
 Install PACTware .
 Install the DTM Collection HART Multiplexer.
 Install HART Comm DTM.
 Install Generic HART DTM.
 Install field devices specific DTMs as necessary.
The cross-device properties of the software are described in the "PACTware
Process Automation Configuration Tool" manual. For the free manual written in
several languages, please access our website at www.pepperl-fuchs.com/pa via
Software > PACTware.
Below please find the device-specific settings for HART Multiplexer KFD2-HMM-16
only.
Connect the PC to the device
 Mount the device on the Termination Board (see section 4.1).
 Connect the device to the power supply.
 Use the RS232 / RS485 converter to connect the PC up to the device.
RS 232 side: COM interface on the PC
RS 485 side: corresponding terminals on the Termination Board
TM
 Start the PACTware
Configuration Tool" manual.

The PACTware
Project window
TM
Figure 6.1 PACTware main window
as described in the "PACTware
TM
main window is indicated.
Edit window
TM
TM
TM
Process Automation
29