HART Multiplexer System KFD*-HM*-16
Installation
4
Installation
4.1
Mounting
Wall or panel mounting
Mounting on
DIN rail
Note
The K-System allows three different types of mounting:
1. wall or panel mounting
2. mounting on 35 mm DIN EN 60715 mounting rail
–
TH 35-7.5 (installation height 7.5 mm)
–
TH 35-15 (installation height 15 mm, material thickness 1.5 mm)
3. mounting on 35 mm DIN rail with a Power Rail insert
Panel mounting is only recommended when a very small number of isolation
components must be installed.
Mounting the device on the wall.
Pull the two clip fasteners out of the back of the device until the clips audibly click
into place.
Fasten the device to the wall or panel with 3 mm screws.
The device is mounted
When mounting on DIN rail, the device is simply snapped into place.
Figure 4.1
The wiring effort for power supply with the isolation modules of the K-Systems can
be greatly reduced by using Power Rail.
Power 24 V DC
19