Pepperl+Fuchs KFD HM 16 Series Manual page 46

HART Multiplexer System KFD*-HM*-16
Configuration
Note
46
After the scan, the right table will show the following information on the DTM
suggested:
• Manufacturer ID
• Device type
• Sub Device Type
• Name of the DTMs
• Manufacturer of the DTMs
• Description of the DTMs
• Extended description of the DTMs (e. g. version number)
Some DTMs do not provide this information, due to which an automatic allocation is
not possible.
Figure 6.17 Result of HART Scan
 Now the DTMs can be added to the project by using the Add button
It is also possible to add DTMs manually in the project tree.
Manual adding of DTMs
 Use the right mouse button to click on the Slave unit where the new device shall be
added.
 Select the device which shall be added.
 Select the loop the device will be connected to.