Table of Contents
Advertisement
HART Multiplexer System KFD*-HM*-16
Configuration
42
Before start the HART Scan select the desired options:
Setting Scan functions
Open the Scan parameters via Settings folder.
The Settings window is indicated.
The following parameters are adjustable:
•
Start Scanning for active slaves: This option is used to determine whether a
search for connected Slaves is to be run.
•
Add found slaves: This option is used to determine that the Slaves found are
added to the project.
•
Connect found slave DTMs: An automatic connection is established to the
Slaves found.
•
Make scanning for HART devices: This option is used to determine whether a
search for connected HART devices is to be run.
•
Automatically add found devices to project: This option is used to determine
that the HART devices found are added to the project.
•
Use generic HART DTM (In case if after scan no device DTM was
assigned): If no HART DTM has been installed for the device found, the generic
HART DTM will be added instead.
•
Use first available device DTM (In case if after scan more then on device
DTM was assigned): If several DTMs have been installed for a device found, the
first DTM found will be added to the project.
Figure 6.13 Parameterization of HART Scan function
Advertisement
Table of Contents
