7
7.1
7.2
7.3
© Martin Engineering GmbH
Storage, De-installation and Disposal
Storage
For your product to work optimally, Martin Engineering recommends
that you store the components made of rubber or urethane in dry
condition at room temperature and protect them from exposure to di-
rect sunlight.
The optimum conditions for storage are at a temperature of +0°C to
+30°C and 60% relative humidity.
De-installation
De-installation is done in reverse sequence of the steps involved in
installation (refer to chapter 5.2.3, page 18).
Disposal
Assemblies and/or single components or parts of the products of
Martin Engineering must be disposed of properly and professionally
after use.
• Complete assemblies should be de-installed and
separated according to material type and disposed of.
When disposing of components and materials, all national and inter-
national waste disposal regulations must be observed.
30
M3618UK-11/14