Silicon Laboratories Si4704 Series Programming Manual page 89

Property 0x1205. FM_RSQ_MULTIPATH_HI_THRESHOLD (Si4706/40/41/49 Only)
Sets the high threshold which triggers the RSQ interrupt if the Multipath level is above this threshold. The CTS bit
(and optional interrupt) is set when it is safe to send the next command. This property may only be set or read
when in power up mode. The default is 127.
Default: 0x007F
Step: 1
Range: 0-127
Bit D15 D14
Name 0 0
Bit Name
15:7 Reserved
6:0 MULTH
Property 0x1206. FM_RSQ_MULTIPATH_LO_THRESHOLD (Si4706/40/41/49 Only)
Sets the low threshold which triggers the RSQ interrupt if the Multipath level is below this threshold. The CTS bit
(and optional interrupt) is set when it is safe to send the next command. This property may only be set or read
when in power up mode. The default is 0.
Default: 0x0000
Step: 1
Range: 0-127
Bit D15 D14
Name 0 0
Bit Name
15:7 Reserved
6:0 MULTL
D13 D12 D11 D10
0 0 0 0
Always write to 0
FM RSQ Multipath High Threshold.
Threshold which triggers the RSQ interrupt if the Multipath is above this threshold.
Default is 127.
D13 D12 D11 D10
0 0 0 0
Always write to 0
FM RSQ Multipath Low Threshold.
Threshold which triggers the RSQ interrupt if the Multipath is below this threshold.
Default is 0.
Confidential Rev. 0.2
D9 D8 D7 D6 D5
0 0 0
Function
D9 D8 D7 D6 D5
0 0 0
Function
AN332
D4 D3 D2 D1 D0
MULTH[6:0]
D4 D3 D2 D1 D0
MULTL[6:0]
89