Silicon Laboratories Si4704 Series Programming Manual page 138

AN332
Bit D7
STATUS CTS
Bit Name
7 CTS
6 ERR
5:4 Reserved
3 RSQINT
2 SAMEINT
1 ASQINT
0 STCINT
138
Table 18. Status Response for the WB Receiver
D6 D5 D4
ERR X X
Clear to Send.
0 = Wait before sending next command.
1 = Clear to send next command.
Error.
0 = No error
1 = Error
Values may vary.
Received Signal Quality Interrupt.
0 = Received Signal Quality measurement has not been triggered.
1 = Received Signal Quality measurement has been triggered.
SAME Interrupt (Si4707 only).
0 = SAME interrupt has not been triggered.
1 = SAME interrupt has been triggered.
Audio Signal Quality Interrupt.
0 = Audio Signal Quality measurement has not been triggered.
1 = Audio Signal Quality measurement has been triggered.
Seek/Tune Complete Interrupt.
0 = Tune complete has not been triggered.
1 = Tune complete interrupt has been triggered.
Confidential Rev. 0.2
D3 D2
RSQINT SAMEINT
Function
D1 D0
ASQINT STCINT