Silicon Laboratories Si4704 Series Programming Manual page 144

AN332
Arg Bit Name
1 7:0 Reserved
2 7:0 PROP
3 7:0 PROP
4 7:0 PROPV
5 7:0 PROPV
Command 0x13. GET_PROPERTY
Gets a property as shown in Table 17, "WB Receive Property Summary," on page 137. The CTS bit (and optional
interrupt) is set when it is safe to send the next command. This command may only be sent when in powerup
mode.
Command arguments: Three
Response bytes: Three
Command
Bit D7
CMD
ARG1
ARG2
ARG3
Arg Bit Name
1 7:0 Reserved
2 7:0 PROPG
3 7:0 PROPG
144
Always write to 0.
[7:0]
Property High Byte.
H
This byte in combination with PROP
modify.
[7:0] Property Low Byte.
L
This byte in combination with PROP
modify.
[7:0] Property Value High Byte.
H
This byte in combination with PROPV
[7:0] Property Value Low Byte.
L
This byte in combination with PROPV
D6 D5
0 0 0
0 0 0
Always write to 0.
[7:0] Property High Byte.
H
This byte in combination with PROP
[7:0] Property Low Byte.
L
This byte in combination with PROP
Confidential Rev. 0.2
Function
is used to specify the property to
L
is used to specify the property to
H
is used to set the property value.
L
is used to set the property value.
H
D4 D3 D2
1 0 0
0 0 0
PROPG [7:0]
H
PROPG [7:0]
L
Function
is used to specify the property to get.
L
is used to specify the property to get.
H
D1 D0
1 1
0 0