Table of Contents
Advertisement
5.
Laser Signal Connection: Connect the connector of laser signal cable to the
receptacle labeled laser interface on the back of eDrive (see Figure 2-14). Once it is
aligned, the connector can be pushed in. Turn the locking ring of the connector in the
clockwise direction until it is locked.
6. Interlock Shorting BNC Connection: Connect the three BNC shorting connectors
to TRIGGER/GATE IN, QSW THERM INTLK, and INTERLOCK as shown
below.
© 2019 Cutting Edge Optronics, Inc.
Figure 2-14. RF Signal Cable
Figure 2-15. BNC Interlock Connection
15
Chapter 2: Laser System Setup
Patara End-Pumped Laser Quick Start Guide
Approved for Public Release; NG19-1901
Advertisement
Table of Contents
