Table 3-1. Edrive Settings - NORTHROP GRUMMAN Patara EPL-016-QTG Quick Installation Manual

3. Check all the laser parameters in the eDrive. The menu designations will help locate
the settings. Use the following values for the Patara EPL:
Main Menu
Channel Setup
Channel Setup
Channel Setup
Comm 0 (Set
Channel Setup COM 0 to OVEN
TEC)
© 2019 Cutting Edge Optronics, Inc.

Table 3-1. eDrive Settings

Menu 2 Menu 3
Q-Switch
Q-Switch Set FPS Settings
Channel 1
Chapter Three: Laser Optimization and Tuning
Parameter
Internal Trigger
Q-Switch
Set Frequency
Set Window Width
Set Q-Switch Power
FPS
Set FPS Mode
Set FPS Delay
-More-
Set Start Power
Set Window Length
FPS Modulation
Type
-More-
PPK Open Offset
PPK Closed
Offset
Channel
Set Current
-More- Set Slew Rate
Slew Control
Set Standby Current
-More- Set Current Limit
Fault Setup
Set Voltage Dropout
Current Tolerance
Set Current
Tolerance
TEC (Note, must be
Disabled to change
settings, and
Enabled last)
Set Temp.
Set Tolerance
Range
-More-
Set Output Voltage
Set Min. Temp.
Set Max. Temp.
-More-
Set P Const.
Set I Const.
Set D Const.
19
Setting or Value
Enabled
Enabled
See ATP
See ATP
100%
Enabled
Standard
See ATP
See ATP
See ATP
See ATP
0 µs
+00 ns
Enabled
See ATP
10.0 A/S
Enabled
See ATP
Factory set; see eDrive
Menu map setting
document
9 V
Disabled
1.0 A
Enabled
See ATP
+1.5 °C
5.0 V
+22.0 °C
+45.0 °C
+4.0 °C
2.00 rep/min
0.00 cycles/min
Patara End-Pumped Laser Quick Start Guide
Approved for Public Release; NG19-1901