Table of Contents
Advertisement
3. Connect diode power. Remove the end cap and connect the female connector of the
diode power cable to the J2 connector on the laser head (see Figure 2-7). Once it is
aligned, the connector can be pushed in. Turn the locking ring of the connector in the
clockwise direction until it is locked.
4. Connect laser signal. Align the female connector of the laser signal cable to the J1 connector
on the laser head. Once it is aligned, the connector can be pushed in. Turn the locking ring of
the connector in the clockwise direction until it is locked as shown in Figure 2-8.
© 2019 Cutting Edge Optronics, Inc.
Figure 2-7. Diode Power Connection
Figure 2-8. Laser Signal Connection
12
Chapter 2: Laser System Setup
Patara End-Pumped Laser Quick Start Guide
Approved for Public Release; NG19-1901
Advertisement
Table of Contents
