Table of Contents
Advertisement
1. Plumbing Connection: Push the barb fittings of coolant hose connectors gently into the
COOLANT IN and COOLANT OUT ports by following the flow path direction. Wetting
the o-rings of the quick disconnect fittings and receptacles can prevent the o-ring from being
cut by the mating piece during insertion. Make sure that the quick disconnect fittings are
locked. A click is heard once it is locked.
2.
Connect RF Cable: Connect the Q-switch RF cable to the BNC connector on the
laser head (see Figure 2-6). Once it is aligned, the connector can be pushed in. Turn
the locking ring of the connector in the clockwise direction until it is locked.
© 2019 Cutting Edge Optronics, Inc.
Figure 2-5. Plumbing Connection
Figure 2-6. Signal Connection
11
Chapter 2: Laser System Setup
Patara End-Pumped Laser Quick Start Guide
Approved for Public Release; NG19-1901
Advertisement
Table of Contents
