Table of Contents
Advertisement
2.
White Interlock Connection: Connect the 2-pin white interlock shorting connector
as shown below.
3. Connect RF cable. Connect the QS RF cable to the RF OUT 1 connector as shown
in Figure 2-12.
4.
Diode Power Connection: Connect the male connector of the diodes power cable
to the receptacle labeled ARRAY POWER on the back of the eDrive
© 2019 Cutting Edge Optronics, Inc.
Figure 2-11. White Interlock Connectors
Figure 2-12. RF Cable
Figure 2-13. Diode Power Cable
14
Chapter 2: Laser System Setup
Patara End-Pumped Laser Quick Start Guide
Approved for Public Release; NG19-1901
Advertisement
Table of Contents
