© 2018 Cutting Edge Optronics, Inc.
Figure 4-11. RF Connection
2. Connect diode power. Connect the diode power cable to the receptacle
ARRAY POWER as shown in Figure 4-12. Once it is aligned, the connector
can be pushed in. Turn the locking ring of the connector in the clockwise
direction until it is locked.
Figure 4-12. Diode Power Connection
3. Connect laser signal. Connect the male connector of laser signal cable to the
receptacle labeled laser interface on the back of eDrive (see Figure 4-13).
Once it is aligned, the connector can be pushed in. Turn the locking ring of the
connector in the clockwise direction until it is locked.
Chapter Four: Installation and Operation
31
Patara I and II Laser User Manual