Teknor Industrial Computers VIPer 821 Technical Reference Manual page 44

    
 !.+     
 !.+     
 !.+     
 !.+
Analog RGB VGA signals are available for direct CRT display connection through the J13
VGA CRT connector located on the edge bracket.
SETUPS
Related Jumpers
To disable the onboard video controller, remove the jumper from the pin 5 and 6 of the W13
jumper (Extended BIOS Modes).
BIOS Level
The CRT Only operation mode must be set at the BIOS level, Standard CMOS Setup option.
Other configurations are: Flat Panel Only, or simultaneous CRT/Flat Panel ( both ).
MAKING CONNECTIONS
The CRT monitor connects directly to the VIPer 821 through the J13 VGA CRT connector
located on the edge bracket.
MORE ...
In simultaneous CRT/Flat Panel mode (same application on both the CRT and the flat panel
displays), the resolution of the CRT display is imposed by the resolution selected for the flat
panel display (See the Flat Panel description on the next page).
3-22