Teknor Industrial Computers VIPer 821 Technical Reference Manual page 38

 ,  
 $ !/ !0  ,  
 $ !/ !0  ,  
 $ !/ !0  ,  
 $ !/ !0
The board supports up to two hard disk drives through the J1 IDE connector (Primary
interface), in Master/Slave configuration.
Connecting a hard disk drive requires a standard IBM 40-pin hard disk cable.
SETUPS
Related Jumpers
No jumper setting is required.
BIOS Level
Standard setups are provided at the Standard CMOS Setup option.
To setup the disk boot sequence, refer to the BIOS Features Setup option.
Other setups are provided at the Integrated Peripherals Setup option
MAKING CONNECTIONS
A standard IBM 40-pin adapter cable is required to connect a hard disk drive. An 18" flat cable
is available from TEKNOR and is referred to as #150-259.
MORE ...
When installing two hard disks, both are connected in parallel. The recognition between
Master and Slave device is provided by the jumper settings supported on the devices.
3-16