Teknor Industrial Computers VIPer 821 Technical Reference Manual page 99

46-4D Reserved
4E Manufacturing POST Loop or
Display Messages
4F Security Check
50 Write CMOS
51 Pre-boot Enable
52 Initialize Option ROMs
53 Initialze Time Value
60 Setup Virus Protect
61 Set Boot Speed
62 Setup NumLock
63 Boot Attempt
B0 Spurious
B1 Unclaimed NMI
E1-EF Setup Pages
FF Boot
Reboot if Manufacturing POST Loop pin is set.
Otherwise display any messages (i.e., any non-fatal errors that were
detected during POST) and enter Setup.
Ask password security (optional).
Write all CMOS values back to RAM and clear screen.
Enable parity checker.
Enable NMI, Enable Cache before boot.
Initialize any option ROMs present from C8000h to EFFFFh.
Note: When FSCAN option is enabled, will initialze from C8000h to
F7FFFh.
Initialize time value in 40h: BIOS area.
Setup virus protect according to Setup.
Set system speed for boot.
Setup NumLock status according to Setup.
Set low stack.
Boot via INT 19h.
If interrupt occurs in protected mode.
If unmasked NMI occurs, display:
Press F1 to disable NMI, F2 reboot.
E1 - Page 1, E2 - Page 2, etc.
E-7
BIOS Setup Error Codes