Teknor Industrial Computers VIPer 821 Technical Reference Manual page 7

50-pin High Density Flat Panel Connector
The J8 Flat Panel connector found on the VIPer821 is a 50-pin high density
connector, which has a different pinout than most dual row headers. The pin
numbers are shown below.
In the same way, the mating connector on the Flat Panel Cable (TEKNOR # 150-
105), has the same linear pinout, as shown above. Two 25-pin flat cables are
crimped to this connector: one cable has pins 1 to 25, while the other cable has
pins 26 to 50.
Flat Panel cable Length
The flat panel cable length for the SBC should be cut on the unconnected end to a
recommended maximum length of 18 inches from the high-density connector.
Though some Flat Panels may support longer flat cables, and TEKNOR has made
allowance for this by providing more than 18 inches of cable, it is the customer's
responsibility to ensure that the additional length is fully supported by the Flat
Panel's specifications.
Read Me First 5
Read Me First