E. Bios Setup Error Codes - Teknor Industrial Computers VIPer 821 Technical Reference Manual

E. BIOS SETUP ERROR CODES

E.1 POST BEEP
POST beep codes are defined in the BIOS to provide low level tone indication when an
error occurs during the BIOS initialization.
Beep codes consist of a combination of long and short beeps. They are described as
follows:
Beep Codes
Post code Beep Code
41
22
33
44
55
LEGEND
Symbol Description
* 1 Beep code
- Silence
E.2 POST MESSAGES
During the Power On Self Test (POST), if the BIOS detects an error requiring you to do
something to fix, it will either sound a beep code or display a message.
If a message is displayed, it will be accompanied by:
"PRESS F1 TO CONTINUE, DEL TO ENTER SETUP".
**-* Enterring the boot block recovery code (i.e. Main BIOS
checksum error)
*-*-* Error when getting the boot block flash ID code
*-*-*-* Error when erasing the boot block flash
*-*-*-*-* Error when programming the boot block flash
*-* Success of the boot block recovery code. The board is ready to
be manually reset.
Description
E-1