Chapter 4 Display and Operation|ASDA-A2 Series
Figure 4.6
NOTE
1) As the display of P4-06 is hexadecimal, 0(zero) of the fifth digit will not show on the LED display.
4.4.4 DI Diagnosis Operation
Following the setting method in Figure 4.7 can perform DI diagnosis operation (parameter P4-07, Input
Status). According to the ON and OFF status of the digital inputs DI1 to DI8, the corresponding status
will display on the servo drive LED display. When the Bit is set to "1", it means that the corresponding
digital input signal is ON. (Please also refer to Figure 4.7)
For example:
Suppose that the servo drive LED display is "3FE1".
"E" is hexadecimal, which is equal to "1110" in binary system, and it means that the digital inputs DI6 ~
DI8 are ON.
4-9
Revision April, 2010