Cabinetry Applications; Framed Cabinetry - Sub-Zero Manual

C A B I N E T R Y A P P L I C A T I O N S
Integrated refrigeration is compatible with virtu-
ally any style and look of cabinetry. The models
can be used with framed as well as frameless
cabinets. Because of the precise application and
the look you may want to achieve, there are
important questions you need to answer before
ordering panels for the doors/drawers. As you
look at styles of cabinets, keep some important
facts in mind:
P A N E L
IMPORTANT NOTE: The depth of each Inte-
R E Q U I R E M E N T S
grated model is 610 mm from the front of the
unit to its back. You must allow for the thick-
Door and drawer
ness of the panel you are applying when
panels must be a
minimum of 16 mm
planning for the finished rough opening depth if
thick.
you want the front panel to be flush with
The door panel
surrounding cabinetry. You must move the unit
cannot exceed 18 kg
back into drywall or bring the cabinets forward
and each drawer
to achieve a flush fit.
panel must not
exceed 5 kg for 686
The height of the door panel can grow beyond
mm wide units. For
1153 mm and exceed the 2032 mm overall
914 mm wide units,
the door panel height as long as you stay below the recom-
weight limit is 24 kg
mended door panel weight limit.
and 7 kg for each
The toe kick clearance can vary with the height
drawer panel.
of the lower drawer panel; the maximum panel
height is 424 mm. You must keep a minimum
space of 102 mm clear below the bottom edge
of the lower drawer panel so the unit can be
properly vented.
We recommend using D-style handles. For the
cabinet door, handles must be located near the
edge of the panel opposite the hinge, centered
top to bottom. Locate handles in the top center
area of the drawer panels.
IMPORTANT NOTE: The inside edges of the
rough opening, as well as the sides and a
portion of the backside of the decorative panels
will need to be finished, as they will be exposed
when the doors are open.
SUB-ZERO
UNIT
CABINET
FRAME
CABINET
DOOR PANEL
10 mm
DOOR
REVEAL
686 mm
OR
Traditional frame – full overlay
(top view)
36
610 mm
TO WALL
CABINET
FRAME
CABINET
DOOR
914 mm
Traditional frame – standard overlay
(top view)
F R A M E D C A B I N E T R Y
Framed cabinetry applications present you with
different questions to address. The illustrations
below show common applications of framed
cabinetry. These are not meant to be the only
alternatives, but are suggestions from designers
around the country. Also refer to the full-scale
illustrations at the end of this section for
specifics on door openings.
NOTE: In the illustrations below, the first width
dimension shown is for 686 mm wide units and
the second dimension is for 914 mm wide units.
610 mm
SUB-ZERO
UNIT TO WALL
DOOR PANEL
10 mm
REVEAL
686 mm 914 mm
OR
SUB-ZERO
UNIT
CABINET
FRAME
CABINET DOOR PANEL
10 mm
DOOR
REVEAL
686 mm
OR
Traditional frame – 10 mm offset
(top view)
610 mm
TO WALL
914 mm