Sub-Zero Manual page 41

As the reveal between cabinets and the
Integrated unit decreases, the potential
exists for severe finger pinching or crushing
if a hand or fingers are placed in the
opening when the door is closing.
681 mm
3 mm* min
REVEAL
19 mm
PANEL
635 mm
CABINETRY
610
OR SIDE mm
PANEL
TO BACK
OF UNIT
SUB-ZERO
*SUBTRACT PANEL WIDTH FROM CABINETRY OPENING TO DETERMINE ACTUAL WIDTH OF REVEAL
910 mm
3 mm* min
REVEAL
19 mm
PANEL
635 mm
CABINETRY
OR SIDE
610 mm
PANEL
TO BACK
OF UNIT
SUB-ZERO
*SUBTRACT PANEL WIDTH FROM CABINETRY OPENING TO DETERMINE ACTUAL WIDTH OF REVEAL
1372 mm
681 mm
3 mm* min
REVEAL
19 mm
PANEL
DOOR DOOR
SUB-ZERO
UNIT UNIT
1829 mm
910 mm
3 mm* min
REVEAL
19 mm
PANEL
DOOR DOOR
SUB-ZERO
UNIT UNIT
When 19 mm or thicker panels are used
and a reveal less than 6 mm is maintained,
the door panels may cause damage to the
Sub-Zero unit when the door is open at the
maximum 105˚ stop. You should use the
built-in 90˚ stop to prevent damage.
3 mm* min
REVEAL
635 mm
CABINETRY
OR SIDE
PANEL
3 mm* min
REVEAL
635 mm
CABINETRY
OR SIDE
PANEL
P A N E L
R E Q U I R E M E N T S
Door and drawer
panels must be a
minimum of 16 mm
6 8 6 m m
thick.
W I D E M O D E L S
The door panel
cannot exceed 18 kg
Panel width dimen-
and each drawer
sions for installation
panel must not
of two 686 mm wide
exceed 5 kg for 686
tall units side by
mm wide units. For
side.
914 mm wide units,
the door panel
Dimensions are based weight limit is 24 kg
on a 3 mm reveal. A and 7 kg for each
reveal of up to 6 mm drawer panel.
is possible, but panel
dimensions need to be
adjusted accordingly.
9 1 4 m m
W I D E M O D E L S
Panel width dimen-
sions for installation
of two 914 mm wide
tall units side by
side.
Dimensions are based
on a 3 mm reveal. A
reveal of up to 6 mm
is possible, but panel
dimensions need to be
adjusted accordingly.
41