Redundant Power Status - Transition Networks Milan Raven Series User Manual

function. Enable means before the remote converter power off, the
remote converter will send out the alarm notice to the central manager
converter
3. In-Band Loop Back Test: Checking the fiber port connection
status between remote and central site converter. User needs to set a
transfer value, and verify the return value is for verifying if the value
the same as user has set
4. Auto Loop Back Test: Checking the fiber port connection status
between remote and central site converter automatically
5. Bandwidth rate control & Terminal Tx port Config: Bandwidth
rate control terminal UTP port
6. Terminal Tx port Table (Read only): Displaying the terminal UTP
port table information
8. Auto Polling: Set the value as 'True' to enable auto polling. When Auto
Polling is set as 'True', the management board then is able to
communicate with the particular module.
Q. Quit: Exit from the current interface

Redundant Power Status

It shows current power supply status. The device has two slots for Power
20