Requirements For Installation; Required Information; Required Equipment - Intuicom RTK Bridge-X Installation Manual

Overview
®
The Trimble 252/262/372 receiver is typically configured to accept CMR format RTK
corrections from an Intuicom RTK Bridge
GPS/GNSS reference network. The intended audience for this document is a dealer or
integrator familiar with the 252/262/372 and generally familiar with the Intuicom RTK Bridge-
X. The Intuicom RTK Bridge-X User Guide covers the steps necessary for its configuration.

1 Requirements for Installation

1.1

Required Information

In order to operate an Intuicom RTK Bridge–X, you are required to have the necessary
information to access and log in to the Real-Time Network. This information is entered
into the RTK Bridge–X and stored in a profile. More details on setting up an RTK
Bridge–X is available in the RTK Bridge-X manual.
IP address,
•
TCP port,
•
NTRIP mountpoint name,
•
username and password for access to the real-time GPS/GNSS network
•
1.2

Required Equipment

1.2.1 Intuicom Equipment and Accessories
1. Intuicom RTK Bridge–X with activated data provider account (Verizon, AT&T, etc...)
2. Intuicom RTK Bridge–X to 252/262/372 data/power cable:
[P/N: XRTKCAB-DD15]
3. Intuicom RTK Bridge–X Cellular/GPS antenna/cable:
[P/N: FIP4-MMDM-MM (magnetic mount)]
1.2.2 Other Equipment and Accessories
1. PC with serial port and Trimble AgRemote Software or monitor with AgRemote or RDI
config available.
2. Trimble 252/262/372 receiver with RTK (CMR) option enabled and Port B available
3. Trimble 252/262/372 Data Cable (50166) and source of power for 252/262/372 (or any
cabling system typically used to run Trimble AgRemote for configuration)
Version 1.0
Section 1: Installation Requirements
®
-X which in turn has been configured to connect to a
2 Intuicom, Inc.