The Solar Charge Controller; The Multifunctionalc; Ontact; The Remote Control - Studer COMPACT C 1600-12 User And Installation Manual

STUDER INNOTEC
4.9 The Multifunctional Contact
In the COMPACT there is a built-in programmable power relay. The potential-free change-over
contact (NO – NC) of this power relay is connected to the screw terminal AUX CONTACT.
Maximum Contact load:
With the Push Button 21 „AUXILIARY CONTACT" the contact can be manually switched on or off
independent of programming and the operating situation. The LED 5 "Contact active" shows the
state of the contact. The drawing up the screw terminal "AUX CONTACT" is the inactive position
mode, LED 5 "Contact active" off.
The switching on and off of this contact can be freely programmed for every operating situation of
the COMPACT witch situation is indicated with a LED. There is no limitation to its application and it
is left to your wishes and desires as to where and how you would like to use it. The example and
the setting of this contact are explained chapter 5.4.2.
In factory we program this for a dysfunction alarm. The contact is active when one of these
situations is detected:
Over temperature (LED 10 lit)
Overload (LED 11 lit)
Over or less voltage of batteries (LED 12 lit or blinking)
COMPACT is turned off manually or with a fault (LED 13 lit)

The Remote Control

4.10
As an option a Remote Control can
be connected to the COMPACT. All
operating controls and displays
except from level adjustment are
available on the Remote Control.
The Remote Control is supplied
with a 20m long cable. It can be
lengthened to 40m. The Remote
Control is suitable for surface
mounting on the wall or on to a
switch board. It is fixed with 4
screws. The COMPACT can also
be programmed with the Remote
Control. The Programming
described in the section „Program-
ming".
The output power and the charging
currents are displayed
Remote Control.
In the Remote Control there is an
additional Alarm Contact and a Control
Input built in. These two functions are
available through Tip-jack RJ11/4 for use.
This Auxiliary Contact is Front / Work
Contact (max. 0.5A!),
independent of the Auxiliary Contact of the
COMPACT. This contact is active in case
of an alarm of the COMPACT.
The Control Input is connected in parallel to the ON/OFF- push button. The COMPACT can be
switched on or off through this input with an impulse button or an impulse contact.
Order Number for Remote Control: RCC-01
Dimensions: H x B x T / 111.5 x 136.5 x 25mm
User manual
-230Vac /16Amp-30Vdc/1A !
COM PACT
RCC-01
SOLAR CHARGE
is
AUXILIARY CONTACT
on the
which is
COMPACT V4.0 E
INVERTER - CHARGER
TRANSFER
AC IN
CHARGER
EQUALIZE
Program
Contact active
Contact manual
(Program)
COMPACT
control
Remote
COMPACT
AC OUT
A %
160
130
INVERTER
70 100
RESET
60 80
ALARM
(Select)
50 60
40 40
Over Temp.
30 20
Overload
20 10
Battery
10 5
Charger
Low/High
Inverter
OFF
ON/ OFF
(Change status)
OFF
ON/
batt
! - !
1 2 3 4
60V/0,5A
max
.
Dry contact
only
18