Internal View - Adaptive Micro Systems AlphaEclipse 3600 A Series Installation Instructions Manual

September 28, 2004

Internal view

Left side wireway sign
A
Ordinary Ordinary
Cube
Controller
Communication
Cube
C
The controller board cube is always on the bottom row and the second cube from the wireway. There is one controller board cube in a sign.
The communication cube is always on the bottom row next to the wireway. There is one communication cube in a sign.
Item Name
A Wireway
B Ordinary cube
8
Shown below is a 64 x 32 pixel sign. Other sign sizes are similar.
Ordinary Ordinary
Cube Cube Cube
Ordinary Ordinary
Board
Cube Cube
Cube
D
Used to route power and communication wires to all the LED modules. Wireways can be mounted on
either the left or right side of a sign. The bottom wireway (shown below) contains the light sensor,
wireway terminal block, and the power terminal block:
The parts inside an ordinary cube can be accessed by either removing the four LED modules from the
front of the cube or by opening the back of the cube (shown below):
LED driver board (back)
AlphaEclipse 3600 Series A Sign Installation Instructions (9711-8001C)
Right side wireway sign
B
Ordinary Ordinary
Cube Cube
Ordinary Ordinary
Cube Cube
Description
Bottom wireway (opened)
Ordinary Ordinary
Cube Cube
Controller
Communication
Board
Cube
Cube
C
D
Power terminal
Light sensor
Wireway terminal block
Cooling fan
AC distribution board
Turbo adapter board
Power supply
Open a sign door slowly. Otherwise
some of the cables attached to the
door may snap off.
Equipment overview
A