Table of Contents
Advertisement
September 28, 2004
Left wireway multi-cube wiring diagram (11800000-22, revision B, sheet 1 of 2)
13
I
W2 - H4
W2 - GND11
TB2
W2 - GND 13
H
LINE 2 (L2)
W2 - GND12
G
W1 - H4
W1 - H3
W1 - GND11
LINE 1 (L1)
TB1
F
W1 - GND 13
TB13
E
TB14
WIREWAY
D
C
NOTES:
B
1) ALL WIRES MUST BE ROUTED FROM THEIR ORIGIN TO THE HINGE AND THEN CONTINUE (AS SHOWN IN DETAIL B) TO ALLOW DOOR TO OPEN TO ITS FULLEST EXTENT.
2) ON COMPLETION OF WIRING, APPLY ANTI-CORROSION SPRAY (P/N 67010018) TO ALL AC ADAPTER BOARDS (P1-P5), ALL TERMINAL BLOCKS, CONTROLLER BOARD (P1),
ALL POWER SUPPLY TERMINALS (PS), ALL TURBO BOARD CONNECTIONS (TB1-TB7 AS NEEDED), AND ALL DRIVER BOARD CONNECTIONS (P3-P4).
BE CAUTIOUS NOT TO SPRAY ANY LABELS AS THE ANTI-CORROSION SPRAY WILL DAMAGE THE LABEL'S ADHESIVE. APPLY AS A FINE MIST ONLY OVER THE WIRE
CRIMP (MORE IS NOT BETTER).
3) ALL GROUND CONNECTORS (GND1, GND2, AND GND3 IN EVERY MODULE) REQUIRE A STAR WASHER (P/N 61820017A) BETWEEN PANELS AND CONNECTORS AND
BETWEEN TWO CONNECTORS. USE SCREW (P/N 61230641) FOR CONNECTIONS.
4) ALL GROUND CONNECTIONS (GND1 AND GND2 IN EVERY WIREWAY) REQUIRE A STAR WASHER (P/N 61820017A) BETWEEN PANELS AND CONNECTORS AND
BETWEEN TWO CONNECTORS. USE NUT (P/N 61620025) FOR CONNECTIONS.
5) FOR AC WIRING USE AID 11800000-09 AND TABLE ON PAGE 2.
A
6) TIE WRAP TURBO AND AC WIRES IN WIREWAY AS NECESSARY. USE ANCHOR 63100029 WITH NUT 62512603 (SEE DETAIL M).
7) REMOVE PROTECTIVE CAP FROM PCB1-SW1.
8) APPLY RTV (P/N 66000002) TO PCB1-P2 (UNUSED TERMINAL PINS) ON THE RIGHT END CUBE.
13
62
12
11
W2 - H3
A
TB12
W1 - GND12
TB11
COLUMN 1 (C1)
A
12
11
AlphaEclipse 3600 Series A Sign Installation Instructions (9711-8001C)
10
CONTROLLER BOARD (PCB4)
L1C1 - GND3
L1C1 - GND2
(INTERNAL TAB) L1C1 - GND1
COLUMN 2 (C2)
MULTI MODULE FRONT VIEW
10
9
9
8
(INTERNAL TAB)
TIE WRAP TOGETHER
DETAIL V
EIGHT CHANNEL CONTROLLER
TYPICAL WIRE ROUTING
8
7
7
Appendix
Advertisement
Table of Contents
