Table of Contents
Advertisement
AlphaEclipse 3600 Series A Sign Installation Instructions (9711-8001C)
Back and side views
Shown below is a 64 x 32 pixel sign with the wireway on the right side of the sign. Other sign sizes are similar.
Side view
(wireway side)
E
D
C
Item
Name
A
Cube support frame
B
Conduit holes
C
Optional conduit holes
D
Wireways
E
Lifting hook
Wireway connection
F
holes
Equipment overview
B
Each cube is attached to the cube support frame:
Four punchout holes located on the bottom of the wireway. These holes can be used to attach conduit in
order to route power and communication wires to the sign.
Locations where up to 1.38-inch conduit holes can be drilled.
Used to route power and communication wires to all the LED modules.
Used to lift the sign during installation. These hooks should be removed after the sign is installed.
Used to route power and communication wires between each LED module.
Back view
A
Description
September 28, 2004
Side view
(non-wireway side)
F
7
Advertisement
Table of Contents
