Table of Contents
Advertisement
AlphaEclipse 3600 Series A Sign Installation Instructions (9711-8001C)
How to open a sign from the front
If it is not possible to open the back of the cube, remove the four LED modules from the front of the cube:
A LED module must be put back into the same location from where it was removed.
1.
Remove power from the sign.
2.
Locate the hex tool access hole in the LED module that is to be removed:
Insert the hex tool into the LED cube access hole. Turn counterclockwise to open the latch. Then lift the
3.
LED module up and pull it back and out of the LED module:
4.
Unhook the data and the power cables from the back of the LED module. Then remove the LED module
from the cube:
Data cable
Power cable
Appendix
Hex tool access hole
5/32-inch hex tool
(pn 6811-7076)
WARNING
Hazardous voltage.
Contact with high voltage
may cause death or serious
injury.
Always disconnect power to
unit prior to servicing.
SM1000A
LED module
If more than one LED module is
removed, keep track of the
location of each module. Each
LED module must be put back in
its original location.
Also, each LED module has its
own data and power cable.
The drawing on the right shows
how LED modules are named.
September 28, 2004
TOP
TOP
LEFT
RIGHT
BOTTOM
BOTTOM
LEFT
RIGHT
FRONT VIEW
33
Advertisement
Table of Contents
