Replace Microphone Protectors - Cochlear Baha 5 User Manual

Wear a Snugfit
The Snugfit holds your sound processor more
securely in place than an earhook alone. It gives
carers easy access to controls and accessories and
is available in large, medium and tamper resistant
(small).
Attach a Snugfit
See figure
1 Press firmly on the top of the earhook with
your thumb to click it off the sound processor.
Click your Snugfit into place
2
Carefully bend the lower part into shape to suit
3
your ear.
Remove a Snugfit
Remove your Snugfit by clicking it off the
4
processor.
Wear a Mic Lock
See figure
The Mic Lock helps hold the processor securely on
the ear.
To attach the Mic Lock the first time:
Push the Mic Lock band onto the processor
1
with the tubing facing forward.
Place the processor on your ear and bring the
2
tubing up to the earhook.
3 Trim the tubing to a length that will hold the
processor firmly in place without discomfort.
Do not cut it too short.
Soften the end of the tubing in warm water
4
and push it onto the tip of your earhook.
5 Let the tubing cool before wearing
13
14
Attach and remove processor covers
See figure 15
To attach, slide the cover onto the processor.
1
2 To remove, pull the cover away from the
processor.
Note: Snugfit, Mic Lock, and Processor covers are
available as accessories. For more information,
ask your hearing care professional or visit www.
cochlear.com

Replace microphone protectors

See figure 16
Replace your microphone protectors every
three months, whenever they look dirty or
whenever you notice any loss in sound
quality. Always replace both microphone
protectors at the same time.
Remove microphone protectors
Remove the protective cap from the
1
Microphone Protector Removal Tool.
2 Push the tip of the tool into the middle of the
microphone protector.
Turn the tool 90° clockwise
3
Lift out the microphone protector and discard.
4
Repeat steps 2 to 4 to remove the other micro-
phone protector.
English
9