Replace Microphone Protectors - Cochlear Baha 5 SuperPower User Manual

Wear a Mic Lock
The Mic Lock helps hold the processor securely on
the ear.
To attach the Mic Lock the first time
1 Push the Mic Lock band onto the processor
with the tubing facing forward.
Place the processor on your ear and bring the
2
tubing up to the earhook.
Trim the tubing to a length that will hold the
3
processor firmly in place without discomfort.
Do not cut it too short.
4 Soften the end of the tubing in warm water
and push it onto the tip of your earhook.
Let the tubing cool before wearing.
5
Attach and remove processor
covers
See figure 17
To attach, slide the cover onto the processor.
1
To remove, pull the cover away from the
2
processor.
Note: Snugfit, Mic Lock, and Processor covers
are available as accessories. For more information,
ask your hearing care professional or visit
www.cochlear.com
16
See figure

Replace microphone protectors

See figure 18
Replace your microphone protectors every three
months, whenever they look dirty or whenever
you notice any loss in sound quality. Always
replace both microphone protectors at the same
time.
Remove microphone protectors
1 Remove the protective cap from the
Microphone Protector Removal Tool.
Push the tip of the tool into the middle of the
2
microphone protector.
3 Turn the tool 90° clockwise.
4 Lift out the microphone protector and discard.
Repeat steps 2 to 4 to remove the other
microphone protector.
Insert new microphone protectors
See figure 19
Pull the Microphone Protector Applicator out
1
of its sleeve.
2 With the microphone protectors facing the
processor, gently push the slotted end of the
applicator under the coil cable plug.
Lay the applicator over the processor,
3
aligning the microphone protectors with the
microphones.
4 Press the microphone protectors all the way
into the microphone holes one at a time.
5 Remove the applicator carefully, peeling it
upwards from the earhook end.
English
11