Honeywell TC4S User Manual page 61

Address
%UXa.b.
470
%UXa.b.
471
%UXa.b.
472
%UXa.b.
473
%UXa.b.
474
%UXa.b.
475
ATTENTION
Typical addressing: The following is a typical example of the addressing in
the thermocouple input module. _ab_ in the variable/address refers to the
number of base and slots on which the module is configured.
For instance, in case reading or writing special module variable area, 4th bit
data of a module installed on #0 base and #4 slot, is expressed as follows:
R: Write only for the data for the module in MasterLogic 200 PLC.
R/W: MasterLogic 200 PLC can read and write an instruction to the module.
%U Address : The data that is usually read or written such as conversion
data of special module's internal memory in PLC CPU, which is used to read
or write every time when scanning special area (regularly read data, defined
in module) of special/communication module in MasterLogic 200 PLC is
assigned in the area. As other devices, it is possible to directly use general
instructions such as MOV, CMP, ADD, and so on (on the other hand,
module's parameter area requires PUT/GET instruction).
R200 Isolated Thermocouple Input Module TC4S User's Guide
September 2010
Variable Name
CH2
_ab_CH2_ALMEN Enable/Disable
CH3
_ab_CH3_ALMEN Enable/Disable
CH0 RJC Enable/Disable
_ab_CH0_RJCDS
CH1 RJC Enable/Disable
_ab_CH1_RJCDS
CH2 RJC Enable/Disable
_ab_CH2_RJCDS
CH3 RJC Enable/Disable
_ab_CH3_RJCDS
Honeywell
5. Internal Memory
5.1. Configuration of internal memory
Description R/W
Alarm(PVA/RCA)
Alarm(PVA/RCA)
Signal
Direction
R/W
R/W
R/W
R/W
CPU →
TC
61