Specifications for Leuze end devices
KONTURflex specifications
Settings on the MA
• PROFIBUS address is freely selectable
• Device selection switch at position "0"
Settings on the PROFIBUS
• Module selection:
Dependent on number of beams used, but at least "8 bytes in"
• User Parameters:
"Transparent mode", "Use GSD settings", baud rate 38400, "8 data bits", "No parity",
"2 stop bits";
KONTURflex settings
First, the following settings are to be performed on the device using KONTURFlex-Soft:
• Either "Autosend (fast)" or "Autosend with data in Modbus format"
• Repeat time "31.5 ms"
• Autosend baud rate "38.4 KB"
• 2 stop bits, no parity
82
204i
MA
204i
Leuze electronic