Table of Contents
Advertisement
Selected scanner
Gateway mode
Ring buffer fill level
Received ASCII Frames
ASCII Framing Error (GW)
Number of Received CTB's
Number of Received SFB's
Command-Buffer fill level
Number of received transparent frames
Number of send fieldbus frames
Number of invalid commands
Number of ASCII stack send errors
Number of good ASCII send frames
Table 9.3:
ND
W-Ack
R-Ack
Data loss
Ring buffer overflow
DEX
BLR
Table 9.4:
ASCII start byte
ASCII end byte1
ASCII end byte2
ASCII warm start status
ASCII baud rate
Table 9.5:
DPS reconfiguration request
DPS input data length
DPS output data length
DPS address
DPS identification number
Table 9.6:
Leuze electronic
Currently selected Leuze device (selected via switch S4).
Transparent or Collective mode.
Current fill level of the ring memory in Collective mode (ASCII->Fieldbus).
1024 bytes max.
Number of received ASCII frames.
Number of received framing errors.
Number of CTB commands.
Number of SFB commands.
Current fill level of the ring memory in Command mode (fieldbus->ASCII).
1024 bytes max.
Number of received fieldbus frames without CTB/SFB.
Number of frames sent via the fieldbus.
Number of invalid commands.
Number of frames that the ASCII memory could not send.
Number of frames that the ASCII memory sent successfully.
General gateway information
Current status of ND bit.
Current status of W-Ack bit.
Current status R-Ack bit.
Current status of data loss bit.
Current status of ring buffer overflow bit.
Current status of DEX bit.
Current status of BLR bit.
Current states of the status and control bits
Currently configured start byte
(dependent on switch position S4).
Currently configured stop byte 1
(dependent on switch position S4).
Currently configured stop byte 2
(dependent on switch position S4).
Indicates whether the ASCII memory has detected and accepted a valid
configuration.
Currently configured baud rate
(dependent on switch position S4).
ASCII configuration
Number of Profibus slave reconfigurations.
Currently configured PROFIBUS input frame length in slot 1.
Currently configured PROFIBUS output frame length in slot 2.
Set Profibus address.
Identification number of the Profibus slave.
PROFIBUS configuration (only for MA 204 devices)
MA
204i
Configuration
43
Advertisement
Table of Contents
