Specific Feature For The Use Of Hand-Held Scanners; Combi Devices With Rfid) - Leuze electronic MA 204i Technical Description

Modular interfacing unit for leuze ident and rs 232 devices on profibus dp

Table of Contents

Reading out information in service mode

 Set the service switch of the gateway to switch position "MA" (gateway).

 Send a "v" command to call up all service information of the MA 204i.

An overview of the available commands and information can be found in chapter "Reading

out information in service mode" on page 41.

12.7.1 Specific feature for the use of hand-held scanners

(bar code and 2D devices, combi devices with RFID)

Notice!

For a description of device configuration and the required codes, please see the correspond-

ing documentation at www.leuze.com -> Download -> identify -> Bar code hand-held

readers or 2D code hand-held readers.

12.7.1.1 Cable-connected hand-held scanners on the MA

All hand-held scanners and mobile combi devices available in the Leuze electronic product

line can be used with the corresponding connection cable.

When using the MA 204i, the voltage supply of the hand-held scanner (5 V/at 1 A) can be

connected to the interface by means of a cable via the 9-pin Sub-D connector (voltage on

PIN 9). The corresponding cable is to be selected for the respective hand-held scanner and

ordered separately. The 9-pin Sub-D cable (KB JST-HS-300, Part no. 50113397) is

connected to this cable, which is connected to the MA 204i. This cable must also be ordered

separately.

In this example, triggering occurs by means of a trigger button on the hand-held scanner.

12.7.1.2 Cableless hand-held scanners on the MA

All cableless hand-held scanners and mobile combi devices available in the Leuze electronic

product line can be used with the corresponding connection cable via the base station.

A 230 VAC connection (socket) is usually necessary for the charging station. Here, a data

connection of the charging station is established with the MA 204i. The corresponding cable

is to be selected for the respective hand-held scanner and ordered separately. The 9-pin

Sub-D cable (KB JST-HS-300, Part No. 50113397) is connected to this cable, which is

connected to the MA 204i. This cable must also be ordered separately.

In this example, triggering occurs by means of a trigger button on the hand-held scanner.

The following codes for configuring the devices are necessary for these devices as well.

Leuze electronic

Commissioning and configuration

204i

Table of Contents