Panda-Audio Future Impact v3 User Manual page 52

74 Filter cutoff
Remark 1: ​ Modulation (CC1) is routed to both VCF and VCO LFO Modu​ l a​ t ion. This means,
that the depth set in the program will be reached if CC1 is at maximum (127). Practically, the
modulation value(s) in the program will be multiplied with the MIDI controller value / 127.
Beware: if you use the FI with a keyboard and set the Mod Wheel to minimum, CC1 will be at
zero. If, at this point. you disconnect the MIDI keyboard and instead play the FI with your
instrument via the audio input, you will find that there is no LFO modulation in the programs
where you would expect it; this is because CC1 is still at zero. ​ Y ou will need to power the FI
off and on again in order to reset CC1 to its default value of 127.
Remark 2: ​ ​ B reath Controller (CC2) adjusts (logarithmically) the VCF volume of the Main
Mixer output in the same way as the LFO modulations work; when the MIDI breath controller
is at maximum (127) then this corresponds to the preset value in the program. This differs
from Volume Control (CC7) in two aspects:
1. It only adjusts the synth volume, it does not change the input instrument's volume;
2. It is located ​ b efore ​ t he effects, so delay trails, etc. will not be muted when CC2 is
lowered.
Remark 3: ​ Portamento Time (CC5) operates in a similar fashion to CC1 and CC2; when
CC5 is at maximum (127) then this corresponds to the portamento value set in the program
via the ​ P ORTA TIME​ slider in the editor.
Remark 4: ​ MIDI Volume (CC7) is applied to the final output of the FI. It is independent of all
program parameters. It is smoothed and acts logarithmically. Beware: if you use a keyboard
or a MIDI pedal to adjust the volume of the FI and you disconnect it, the volume will only
return to the default maximum value if you power the FI off and on again.
MIDI THRU:​ The MIDI OUT of the FI will pass on all information from its MIDI IN, apart from
CC6 (Data Edit), NRPN controllers and SysEx data. Please note that this feature can be
turned on or off via the ​
Program Change Out:​ When a Program Change occurs on the FI by pressing the Program
footswitch or by receiving a Program Decrement command coming through the MIDI IN, then
the FI will send out the corresponding Program Change command via its MIDI OUT on the
active MIDI Channel. By contrast, if the Program Change occurs by receiving a Program
Change coming through the MIDI IN from an external piece of equipment, then the FI will not
b oot menu​ .
64 Deviates ±1, ±2 or ±4 octaves from the
cutoff value set by the VCF FRQ slider in
the program. Range is set by ​ V CF
CONTROL RANGE​ in the ​ b oot menu​ .
52