Instrument Mode (“Ins”) - Panda-Audio Future Impact v3 User Manual

EDIT dials, you can manually set the tune base to 440 (or any other desired value).
● INSTRUMENT MODE ("InS")
Value: bSS (Bass), SPL (Split), Gtr (Guitar), Snt (Synth), EUI (EWI). (Default on reset
is bSS.)
○ Bass Mode:​ The pitch tracking is optimized and limited for the pitch range of
the bass guitar. The entire range of a 24-fret, 6-string bass is covered.
○ Split Mode:​ A variation of Bass mode, designed for using the FI on stage with
two separate amplifiers (one for bass/guitar, one for synth), or for using in the
studio where having separate bass/guitar and synth channels may be
desired. In this mode you must split the signal prior to the FI's input with a
splitter box or a Y cable for the two destinations.
Everything works as in Bass mode, but with the following differences:
■ The direct audio signal portion of all programs is muted so that only
■ The ON/OFF footswitch will not switch to true bypass when turned
○ Guitar Mode:​ The pitch tracking is optimized and limited for the pitch
range of the 6 string guitar.
○ Synth Mode and EWI Mode:​ Most features of these two modes are the
same.
The audio input is separated from the pitch control and triggering so that an
audio signal can be routed to the VCF and effects without affecting the synth
sounds;
Unlike ​ i n Bass/Split/Guitar modes, the FI will power on in the ON state;
The Tuner feature has no use. Instead, a long press of the right-hand switch
puts the FI into ​ D etune Mode​ , which can be used to set up the FI to play in
non-western tunings.
Once Detune Mode is activated, the following will occur:
■ Any previous detuning applied to notes of the chromatic scale will be
1
Strictly speaking in this case by "synth" we mean the contents of the VCF output, that is, any signal
routed through the filter.
the synth signal is sent to the FI's audio output;
off, instead the output remains connected to the digital circuitry and
all signals are muted.
reset;
1
15