Configuring - Panda-Audio Future Impact v3 User Manual

RESONANCE: ​ B oosts the frequencies around the filter cutoff frequency. Lower values give
a flat, wide peak; higher values give a narrow, sharp peak.
BALANCE: ​ S ets the balance between the bass/guitar sound and the synth sound. A setting
of 9 mutes the dry bass/guitar sound entirely.
LEVEL: ​ S ets the overall output level of the sound.
EFFECTS: ​ S ets the amount of chorus, overdrive or tilt-EQ applied to the sound. For full
details on how the effects are influenced by this parameter see the ​
this manual.
Configuring the Future Impact v3
This is done via a boot menu. Only the two most immediately important parameters of this
menu are shown here; the ​
The default configuration of the FI is for bass.
To enter the boot menu, press and hold the PROGRAM (left) footswitch while powering on
the pedal. Turn the PARAMETER dial to "Note Off Level" to see the name of a parameter
and turn it clockwise to any other position to see that parameter's value. The value is
adjusted using the EDIT dial. Step through the parameters by pressing the left footswitch
again. When editing is complete, turn the FI off and on again.
The aforementioned two parameters of the boot menu are given below:
● RESET ALL ("rS")
Value: 0, 1. (Default on reset is 0.)
Change to 1 to reset all sound para​ m eters to default (5) upon power-on. The default
program loaded at power-on will be reset to 1.
● INSTRUMENT MODE ("InS")
Value: bSS (Bass), SPL (Split), Gtr (Guitar), Snt (Synth), EUI (EWI). (Default on reset
is bSS.)
Choose the option for your instrument. If using an instrument not listed above then
choose either Bass or Guitar, whichever one best fits the pitch range of your
instrument. For a full explanation of each instrument mode, please see the Detailed
Manual.
c omplete list​ is shown in the Detailed Manual.
End of Quick-Start Guide
E ffects Block​ section of
12