● BASS SLOPE (0...127):
Adjusts the steepness of the bass filter in a range of 3...10dB/octave.
● BASS BOOST (-20...+20):
Boosts or cuts the bass by up to 20dB.
● MID1 FRQ, MID2 FRQ (0...127):
Adjusts the center frequency of the equalizer stages in the range of 170...7000Hz.
● MID1 Q, MID2 Q (10...100):
Adjusts the resonance (Q) of the equalizer stages in a range of 1...10.
● MID1 BOOST, MID2 BOOST (-20...+20):
Boosts or cuts the equalizers by up to 20dB.
● TREBLE FRQ (0...127):
Adjusts the frequency of the treble shelf filter in the range of 2000...7000 Hz.
● TREBLE SLOPE (0...127):
Adjusts the steepness of the treble filter in the range of 3...10dB/octave.
● TREBLE BOOST (-15...+15):
Boosts or cuts the treble up to 15dB.
The Equalizer section has an optional graphical editor too (see the
beginning of the Effects Block). Above the Equalizer panel there are two small icons:
The left one selects the panel with sliders (described above); the right one
selects the panel with the graphical editor.
Using the mouse with the graphical editor you can adjust the frequency of a filter stage by
clicking and dragging the yellow dot left and right. You can similarly adjust the boost/cut by
clicking and dragging up and down. Using the right mouse button to click and drag (either
left-right or up-down), you can adjust the steepness of the low and high shelving filters in
dB/octave and the Q value of the mid filters.
Note: Y ou can only assign an EQ parameter as a destination for a Flexi Controller from
within the s lider-based panel. As soon as an EQ parameter has been assigned as a Flexi
destination, the graphical EQ panel will be disabled for as long as the assignment remains in
place. (See the section on
function.)
Effect 3: Chorus
F lexi
Controllers below for a detailed explanation of their
s creenshot
at the
39