Adjusting Effects On The Fi With The Parameter And Edit Dials - Panda-Audio Future Impact v3 User Manual

This effect is very flexible; in addition to Chorus, it can be configured as a Flanger, Slapback
Echo or simple Reverb merely by setting the parameters differently. It consists of two delay
lines and two LFOs. Both LFOs can modulate both delay lines simultaneously by arbitrary
amounts using four fully-independent modulation depth controls.
Since there are two delay lines and two LFOs, there are two identical sets of sliders. For
simplicity they are paired together in the description below.
Moving from left to right, the sliders of this effect are as follows:
● LFO A FRQ, LFO B FRQ (0...127):
Adjusts the frequency of the two LFOs.
● LEVEL1, LEVEL2 (-64...63):
Adjusts the output level of the two delay lines. The ampli​ t ude can be negative, which
is important for flanger sounds if the delay value is very small, or if the two delay
values are very close to each other.
● DELAY1, DELAY2 (0...127):
The delay time can be adjusted here. The maximum value is approximately 160ms. It
is the sound designer's responsibility to ensure that the combination of delay and
modulation settings remains within a usable range.
● MOD1A, MOD1B, MOD2A, MOD2B (0...127):
Adjusts the amount of modulation from LFOs A and B that is applied to the delay
lines 1 and 2.
● FBCK LEVEL (0...127):
Adjusts the feedback level. It is the sound designer's responsibility to set the
feedback level moderately so that no oscillation occurs. Oscillation can choke off the
sound completely; if this happens, simply lower the feedback slider again.
● FBCK DMP (0..127):
Adjusts the feedback damping. This is a lowpass filter applied to the feedback path. It
can emulate the natural damping of walls in a room.
Note:​ LFO A and LFO B can be freely assigned to many other parameters when used as a
control source with a Flexi Controller. (See the section on ​
explanation.)

Adjusting effects on the FI with the PARAMETER and EDIT dials

Setting the data digit on the FI to default (5) using the EDIT dial will reproduce the effects
settings exactly as they were saved in the editor.
The EDIT dial will ​ o nly ​ adjust the ​ l ast ​ a ctive ​ effect in the chain.
When OVERDRIVE is last in the chain, turning the EDIT dial towards 9 will increase DRIVE;
turning towards 1 will decrease it.
F lexi Controllers​ for a detailed
40