intervolt DCC Pro Installation & Operation Manual page 24

10
Configure the Charging Device: Ignition control mode
Following the last step (9) con rm if you
want to enable ignition control mode.
Use the
one of the two following options:
11
Configure the Charging Device: Ignition control setting
The next step is to con rm the ignition control
setting. Use the
of the two following options:
12
Configure the Charging Device: Confirming configuration
Upon successful completion of the above, the
following con rmation message should appear:
ALL GOOD - this indicates your selections have
been sent to the device and accepted. It does not
con rm the integrity of your wiring installation.
In the event a SYS message error is displayed,
disconnect, then reconnect the main battery
positive cable and re-commence step 7. If the
error persists re-check the Data Cable connection.
If this does not resolve the problem, please refer
to the troubleshooting information on page 34.
22
and scroll buttons to select
I. To disable ignition mode select OFF
II. To enable ignition mode select On
III. Press the
button to con rm and
OK
continue to next step.
and
I. Select NORMAL for conventional
(non ECU) charging systems.
II. Select LOW for ECU controlled
electrical systems.
III. Press the
button to con rm and
OK
continue to next step.
buttons to select one